Craftsman Compound Miter Saw 137.212290
Lower handle & bracket
These are new 3D printed parts which have been reverse engineered from the original injection molded parts and redesigned to perform better. Please note that you will have to reuse or source the electrical components and screws/nuts/springs. A great place to to look would be your local hardware store or online at McMaster-Carr. A bit of light sanding may be required. This is made from a high strength PETG material and redesigned from the original parts, however it should remain compatible with original pieces. Please contact me if you have any issues with fitment.
You will receive: - Lower shell half & bracket (replaces 2D9C or 2BPS or 2FJU)
I make these because a friend approached me with her broken handle and said she couldn't find a replacement part anywhere. Sure enough, after a good amount of research, I reached the same conclusion and decided to reverse engineer my own solution from the broken parts. After a few prototype iterations, I reached a design that works great!
Disclaimer: While every attempt was made to provide a safe and functional design, it is the responsibility of the buyer to ensure that they install and use this correctly. If the original part can break, this one can too. Please be careful!